Purchasing Criteria

Buying a non-genuine Evac+Chair may put your operator and passengers at risk and cost more in the long run. When evaluating your intended purchase try before you buy and beware of imitations. They may look the same from a picture but functionality will vary. Here is a checklist to use when looking at purchasing an evacuation chair:

Deployment

Preparation of an evacuation chair for operational use should be fast and simple. Tricky release mechanisms should not be waiting to trap the operator’s finger or hand, nor should the operator be expected to balance the chair with one hand whilst releasing skids, buckles or straps when the chair is occupied.

Weight of Unit

Weight is a major factor, particularly if the evacuation equipment is located in various parts of the building and must be carried to the passenger, or simply removed from its securing location.

Weight to strength ratio of the product is an important consideration, particularly with an upward trend in BMI (body mass index) throughout the population.

Ease of Transfer

The device must be designed to facilitate ease of transfer. PRM’s (person of reduced mobility) may require assistance and the product must be stable, open on both sides and provide passenger safety at all-time.

Ideally, where a wheelchair transfer takes place, both the wheelchair and evacuation chair should be of equal height and supported by an operator for extra stability.

Manoeuvrability

Not all stairways comply with building regulations and may not provide 1.2 meters width on halls, stairs and landings. Make sure your evacuation chair has a good turning circle and that no extra physical exertion should be needed to get around difficult landings and corners.

Speed of Descent

An able-bodied person can descend stairs at a normal walking pace at a rate of 0.75 metres per second.  An evacuation chair should be able to match this with a competent operator.

The Evac+Chair can comfortably achieve two flights of stairs in 15 seconds, or four floors in a minute.

Controlled Speed Descent

The majority of evacuation chairs depend on a rotating belt drive mechanism to span two or more stair nosings. The concept was first invented by David Egen of Evac+Chair Corporation, USA, who designed and registered the Egen Polymatic v-belt as a friction braking device.

Using coefficient of friction, the greater the weight of the passenger, the greater the friction. The friction is increased by adding leverage to the operator handle. We have found several chair types which have no friction and therefore no controlled speed of descent.

Other devices require a cable brake and release mechanism. Virtually all cable brake mechanisms use the “dead man brake” principle and are either “on” or “off” and do not provide a graduated increase or decrease of pressure experienced with, say, a bicycle.

Fire Assembly Point

On reaching the fire assembly point, the product should be free standing and comfortable. The passenger should never be left unattended or left alone, even with devices which have additional braking mechanisms.

After-Sales Support

Ask how long the company has traded and where the manufacturing country of origin is. Finally, check if your supplier can support your training needs and provide after-sales service.

Accreditation

Ask if the evacuation chair is registered with the MHRA (Medical & Healthcare products Regulatory Agency) as a Medical Device Class I. After all, this is a life safety product and someone’s life may depend on it.

    Please complete the form below to request more information.

    *All fields marked with an asterisk are mandatory

    Our Accreditations